Paint protection film is worth it in Seattle for a car that spends its days on I-5 or I-405, crosses the passes in winter, or is one you plan to keep with its factory paint intact. It is harder to justify on a car that rarely leaves city streets, already has a chipped front end, or will be gone before the chips add up.
Paint protection film is shortened to PPF, and it is also sold as clear bra.
What does paint protection film actually do?
PPF is a clear urethane layer fitted over the painted panels that face the road. Grit, gravel and bug splatter hit the film instead of the clear coat, so the chip that would have gone through to the primer does not happen.
The film we install has a self-healing top coat. Light swirls and fine scratches relax out with heat from the sun or with warm water. A gouge deep enough to go through the film does not. The same top coat sheds water, so rain, road film and bugs rinse off it. That matters in summer too: bug splatter across the bumper and mirrors etches clear coat quickly on a hot day, and on film it stays on the top layer and washes off.
Every kit is cut on a plotter for the exact year and model, and we make custom patterns where a vehicle needs one.
Two limits are worth knowing before you spend anything:
- Film protects the paint, not the panel. A hard enough strike can still dent the metal underneath.
- Film does not repair anything. Before it goes on, the paint gets a decontamination wash, clay and a light polish so nothing is sealed under it. The polish does not take out damage that is through the clear coat.
What does a Seattle winter do to a car's paint?
Winter roads here carry sand, gravel and studded-tire grit, and the state transportation department, WSDOT, publishes what its crews put on them.
Studded tires are legal in Washington from November 1 to March 31, and WSDOT says they damage the state's roads every winter. WSDOT uses less sand than it once did but still sands in colder weather, and it says sand can blow off a road fairly quickly and is hard to keep in place under high-speed traffic. Once snow has started falling and accumulating, crews switch to salt pre-wet with a corrosion-inhibited liquid de-icer.
On a car, nearly all of the damage lands on the front: the bumper, the leading edge of the hood, the fenders and the mirror caps. On winter roads the rocker panels and lower doors take it too.
De-icer is the quieter problem. It gets into every chip it finds, which is one more reason to keep chips from starting.
When is PPF worth it in Seattle?
Film is worth pricing when one or more of these describe you:
- You commute on I-5 or I-405. Gravel, sand and de-icer thrown up on the freeway land on the front end.
- You drive over Snoqualmie or Stevens Pass in winter. A trip over the pass means hours behind trucks and plows on a gritty road.
- The paint is still clean. Film keeps what is under it the way it is, so it does the most for a front end that has not been chipped yet.
- You plan to keep the car, or to sell it with its factory paint. Film keeps that paint intact for the day you sell.
- You park on the street or in tight lots. Doors open into doors. Film on the door edges and in the door cups, the recesses behind the handles, stops the small chips and fingernail scratches that collect there.
When is paint protection film not worth it?
We would rather say this than sell you a kit you do not need:
- The front end is already chipped and you are not going to repaint it. Film goes over what is there.
- The car rarely leaves surface streets. A front kit is the coverage to look at first for a car that spends its life on the freeway. Yours does not. Door edges and door cups are the exception, and both are part of the Deluxe kit.
- You will not have the car long. Film then mostly protects paint that is about to be someone else's.
- You expect it to stop dents, or to end washing. It does neither. Filmed panels still get dirty, and the film is washed by hand.
How much of the car needs PPF?
You do not have to cover the whole car. Our kits run from the leading edges to every painted panel:
- Deluxe, a partial front. Up to 20 inches of the hood and fenders, the full front bumper, the headlights and fog lights, the mirror caps, the door edges and the door cups.
- Ultimate, a full front. The whole hood and both fenders with no seam line, plus the bumper, lights, mirror caps, door edges and door cups.
- Track Pack. Everything in Ultimate, plus the rocker panels (the sills under the doors), the lower doors, the A-pillars and roof edge, and the loading edge of the rear bumper.
- Full Vehicle. Every painted panel, plus the headlights and fog lights.
The choice between the first two is mostly about the hood. Deluxe stops partway up the hood and fenders, so there is an edge where the film ends. Ultimate covers both panels whole.
For winter driving, also look at the lower sides. A front kit leaves the rocker panels and lower doors bare, and those are the panels that gravel and winter roads sandblast. Track Pack covers them. There is also a rocker panel add-on, meant for lifted trucks and gravel driveways, if the sills are all you want to add.
Each kit, what it includes and its starting price are on our paint protection film page. The Shoreline PPF page has more on pass trips and tight parking.
What happens after the film goes on?
How long the car stays with us depends on the work, and we tell you when you book. We also tell you how long to leave it before the first wash.
After that, wash it by hand. It rains here on more than 150 days a year, and the top coat sheds that water.
How do you get a price for your car?
If the worth-it list sounds like your car, build a proposal with the kit you are considering and you will have an estimate in a couple of minutes. Or call our Aurora Ave N shop at (206) 306-9896, tell us how you use the car, and we will suggest a kit.
Next step
Get an estimate for your vehicle
Build a proposal in two minutes and the shop checks every line before the final comes back to you.
